• If you log in, the ads disappear in the forum and gallery. If you need help logging in, send request for help to: webmaster@southernairboat.com

Recent content by lycomingkid

  1. lycomingkid

    Ls ignition

    I’ll be using the MSD ignition box 6010 or 6014 on my ls 5.3
  2. lycomingkid

    The dark side is pulling me in

    With the hull that I have I’m limited on prop size and the maximum length of prop that I would be able to run would be a 78in prop being that my hull is 7ft wide at the top. I also plan on adding aluminum to deck in the side to so can walk around the boat that will transition towards the cage...
  3. lycomingkid

    The dark side is pulling me in

    Sorry to let this post fall off I’ve been busy with work and side jobs to help fund this build and I’m hoping to have the majority of the motor put back together I should be getting my pistons and rings sometime next week
  4. lycomingkid

    The dark side is pulling me in

    I’ve been looking for different cam kits and have came across this one what are yalls thoughts on this package
  5. lycomingkid

    The dark side is pulling me in

    Since I haven’t been able to post any pictures I’m cleaning up heads today and getting all the dirt and grime off of them
  6. lycomingkid

    The dark side is pulling me in

    That’s the route I’m going it’s just gonna take me a while to get everything together to build this motor
  7. lycomingkid

    The dark side is pulling me in

    I plan on staying with the 862 heads and swapping out the valve springs with new ones that come with a cam kit and also doing the trunnion upgrade as well
  8. lycomingkid

    The dark side is pulling me in

    It has a set of 862 heads
  9. lycomingkid

    The dark side is pulling me in

    When I have time in the morning I will post pictures of the block heads crank and other miscellaneous parts that came with it
  10. lycomingkid

    The dark side is pulling me in

    Well I finally went and picked up my 5.3 today and I was hoping that it would have been an aluminum block motor but the iron block motor will do just fine
  11. lycomingkid

    The dark side is pulling me in

    In time when I’m able to do so (in a few years) I’ll have a 13-14ft Stossel/Booth hull built to swap the LS into
  12. lycomingkid

    The dark side is pulling me in

    It’ll take me some time to build and gather up the costly parts (gearbox,prop etc.) but in the end I believe I’ll have one heck of a boat when it’s done. One thing is for sure I can’t complain about the little 170 it has always gotten me from point A to point B and back every time and has...
  13. lycomingkid

    The dark side is pulling me in

    Slidin I’ll be sticking with my same hull that the 170 is on now a 12x7 welded Stossel hull which is why I’m limited to a prop diameter of 78 inches . As for what I’m gonna do with the 170 when I’m completely done with the “new build” I’m gonna have the 170 gone through and freshened back up to...
Top