Water_Gremlin
Member
I'm sorry if this is in the wrong section or if it has been posted before, I searched for a bit and couldn't find anything that answered my question.
I have a sbc 350 with a three blade master blaster prop and just noticed there are a couple areas where th leading aluminum edge is seperating from the prop at the seem. There's only a couple sections total and all three blades about an inch long that are starting to seperate. I'm sure there's some kind of epoxy on the market that I could use to keep the edge from seperating even further. Any recommendations or thoughts?
I have a sbc 350 with a three blade master blaster prop and just noticed there are a couple areas where th leading aluminum edge is seperating from the prop at the seem. There's only a couple sections total and all three blades about an inch long that are starting to seperate. I'm sure there's some kind of epoxy on the market that I could use to keep the edge from seperating even further. Any recommendations or thoughts?