-
If you log in, the ads disappear in the forum and gallery. If you need help logging in or getting registered, send request to: webmaster@southernairboat.com
PM to Waterthunder
- Thread starter Muddyduck
- Start date
Waterthunder
Well-known member
Please P.M me with a day time phone number so I can contact you via phone. I have been swamped lately so I have not been returning my Emails. Sorry about that.
thunder, you must be the only one round here thats busy !!!
just kidden.. i want to order a cam(through you)(500 direct drive cad) also ive been lookin at the web site you suggested and theres a couple of different intakes apparently.......do you think the 2115 edelbrock is good enough or what ??? then i think you recommended stickin with a 500 cfm holley 2 barrell ??? you also rec. higher ratio rocker arms.... do you think stamped are ok?? or should i try to get rollers.. then if so what is required to put bbc rollers on the cad ?? are rollers only reqiured for higher rpms or if more aggressive ramp profile, then what ?? what about using the oldsmobile rods??
thunder i am about to disassemble... please assist with the info, thanx
should i see about head work??? please pm me... thanx again
just kidden.. i want to order a cam(through you)(500 direct drive cad) also ive been lookin at the web site you suggested and theres a couple of different intakes apparently.......do you think the 2115 edelbrock is good enough or what ??? then i think you recommended stickin with a 500 cfm holley 2 barrell ??? you also rec. higher ratio rocker arms.... do you think stamped are ok?? or should i try to get rollers.. then if so what is required to put bbc rollers on the cad ?? are rollers only reqiured for higher rpms or if more aggressive ramp profile, then what ?? what about using the oldsmobile rods??
thunder i am about to disassemble... please assist with the info, thanx
should i see about head work??? please pm me... thanx again