M mwood7800 Well-known member Apr 4, 2006 #1 If someone is using a 2 BLADE SIGNITURE SERIES on there 540, what pitch or setting are you using.
L Larry Moderator Apr 4, 2006 #2 My buddy is running a 74" signature on a angle valve 540. He is running at right on the reference mark and it turns up right at 2900rpm. Larry
My buddy is running a 74" signature on a angle valve 540. He is running at right on the reference mark and it turns up right at 2900rpm. Larry
O ONA540 Active member Apr 4, 2006 #3 I'm running a lycoming straight valve (260), 74" power shift turning 2900-2950 on the water. I used an angle finder from home depot, I can't remember what degrees it was, but I will measure and report back
I'm running a lycoming straight valve (260), 74" power shift turning 2900-2950 on the water. I used an angle finder from home depot, I can't remember what degrees it was, but I will measure and report back
B Buck Thruster Well-known member Apr 4, 2006 #4 We set my friends straight valve 540 72" Signature Series right on the factory marks. It turns 2900 rpm.
We set my friends straight valve 540 72" Signature Series right on the factory marks. It turns 2900 rpm.
D duckluv26 Well-known member Apr 5, 2006 #5 same here, 0540 SV set on the reference mark, 2900. make it easy and set the reference mark dead center of the hub and plate the first time.
same here, 0540 SV set on the reference mark, 2900. make it easy and set the reference mark dead center of the hub and plate the first time.
