New member 1st post. I just installed a set on my trailer and was wondering if anyone else has any experience good or bad. I off loaded and power loaded twice from dry ground and they definitely make it a lot easier. The only problem I see is the boat slides side to side on the trailer with only a good push, I have a 14X7.5 Diamondback with ZZ4, l do have side guides so I'm going to jam some closed cell docking fenders in between while trailering. You have to believe the warning sticker about being ready to launch as the boat really slides off!
-
If you log in, the ads disappear in the forum and gallery. If you need help logging in or getting registered, send request to: webmaster@southernairboat.com
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Trailer Sliks
- Thread starter Bigfun
- Start date
A
Anonymous
Guest
I thought about putting them on but did not know if it might warp or leave an ident in my poly. sounds like a great idea , what kind of bottom do you have. I also added a trailer roller near my axial which works great for using my winch for unloading on dry ground.
A
Anonymous
Guest
where did you purchase yours
A
Anonymous
Guest
did you use the 3inch wide or the 1 1/2 strips
A
Anonymous
Guest
All you need on any airboat trailer's runners is a can of $4.00 silicon spray. You spray those runners good with silicon and you can unload it with your little finger anywhere. Try it and see.