what pitch do you have you prop set at?

[josh_2562]

If you could list your prop brand engine and boat size. Thanks josh

 

[Johnboy]

74" Sensenich "Q" Series on 2 mark, 0540, 12'6" Laser

 

[Moritz]

80" Sensenich super wide 4 blade piched @ 2 16 by 8 496 Chev big block

 

[Waterthunder]

Gee a big inch block swinging a ton of prop did everyone tell you to run a 2to1!

 

[jonnybird]

O-320 lycoming 68" sensenich Q at the full 2 mark. 2900 rpm 11x7 3/4 deck.

 

[jh0470]

74” Q Series set on mark 2, 3000RPM’s, Stanley built 0520, 13’-6” Gilileo.

 

[John C]

Sensenich Super Wide 3 Blade set on the #3 mark. 15x8.5 Hamant, 520 Caddy.

 

[fatboy0054]

16x8 Kennedy 506 Cadillac 3 blade 80 inch Superwide @ 2 1/2

 

[CONTINENTAL CRACKER]

220 13' PANTHER 3 BLADE H SENSENICH 21/4 PITCH AT 2850 220 / 0470 CONVERSON INJECTION 12 HAMMANT 3 BLADE H SENSENICH 2600 @ 2 1/2

 

[cont520]

I/O 520 on a 13-3 preditor cut down /72"water walker 2 blade with 15 degrees at the tip 3000 RPMs

 

[CONTINENTAL CRACKER]

CONT.0520 HOW LOW ARE THE SIDES ON YOUR CUT DOWN PREDATORR?

 

[cont520]

15 inches Lil Bob put a false bottom in the mold which lowered the sides

 

[Joe]

14 foot combee 455 buick 2.38 3blade psr by whirlwind 19 degrees at the tip

 

[frank w.]

12ft 220 three blade whirl wind set at 17 degree mark 2800 rpm

 

[ptr34]

14' laser 0470-13 spin 72" 2 blade Q @ 2 pitch mark about 3000

 

[alumitech520]

carb 520on pump gas,74"q series @2850 on #2

 

[mwood7800]

set the thing to get the rpm needed!!!!

 

[dantheairboatman]

14/8 Jimmy white Sen sw #2 80in 268

 

[a1mudpuppy]

15' GTO (Good To Overcharge) HULL ONLY swinging a four blade 80" Whirl Wind Master Blaster 2.3 only by having a Stinger 2.38 bolted to my Caddy 500, pitched on the last mark (25deg)

 

[hobby#4]

76 inch, 8 blade, Warp Drive, 14 deg, 14ft Combee