Recent Airboat Pictures

Click here for the full Southern Airboat gallery

Active Airboat Topics

Recent Forum Topics
  • there is usually a list of the contents on the kits ...I have found the aircraft kits have a lot of parts in them that airboaters don't necessarily use like safety clips etc that are required by the faa for an aircraft carb....as far as the shafts wearing out usually …
    September 22, 2018, 10:18 am by GMAC 76
  • A CAR MOTOR! Just because your first date turned out to be a real bch, did you switch to guys? :stirpot: There are lot's of blown up car motors out there too, and 300 Hp is no where near enough for the weight you are going to add, …
    September 22, 2018, 9:37 am by Slidin Gator
  • is it the right carb with the right jet nozzle?...if its running rough it may just be a mag, plug or wire problem....try a mag drop test at 1800rpm and see if ya got an ign problem...might be a busted impulse spring or carbon track or etc. …
    September 22, 2018, 8:26 am by mojoe
  • Last night we had plenty of water in the back trail , and all the way to the mud lake pavilion, also ran the fence line to the oak head water most of the way .The water was flowing out the marsh behind Prosimian . Nice ride but …
    September 22, 2018, 7:06 am by pontoon outlaw
  • Thank you White Hawk. I believe the LS2 with fuel injection is going is going to put me right whereI need to be with the 2.38 gearbox I now have: leaving only lunch adjustments. I'm working in my polymer now. Then the rigging. My plans are to be on …
    September 21, 2018, 11:10 pm by sarros2004
  • I know I don't want to touch the intake runners, need to them small and rough to tumble the air going in to mix the fuel well. dont know anything about tumbling air, but anywhere air flows in our out should be smooth and blended …
    September 21, 2018, 10:44 pm by Slidin Gator
  • Ok thank you gentlemen, yea it has poly in the bottom but I guess I’ll have some fun with this one for now and save some pennies for a different boat in the future. Thanks again for the input.
    September 21, 2018, 4:07 pm by Paul_bunyan
  • Prop?
    September 21, 2018, 2:25 pm by flcracker9
  • Helping a friend with his build. Looking for 3 R blades RHR with I-Beam to use in a short/med hub to make 78-80". Must be in great shape. Send me a PM with blade and contact info - thanks. :salute:
    September 21, 2018, 9:55 am by kwanjangnihm
  • I just budget built a 6.0 that is around that HP, I bought used and redid top end. I have a 2.68 with a 79" 3 bld R it is on a 14' Alumitec runs fairly well. It is certainly not purpose built, might blow-up tomorrow. Had a stock 5.3 …
    September 21, 2018, 7:57 am by One Eyed Gator