Timing or compression if you have fuel air and spark

The cracks are because it is a chrome cylinder not sure on the metal particles in the oil though I have a lot in mine but mine is copper looking and black stuff

Try Broward power train

It's a 220 gpu or packet pe150 single mag engine

Facet

Are you running a hardened oil pump drive shaft I had a problem with mine on a ford not letting the dizzy go all the way down

I believe you can't use chrome rings and a chrome jug they won't seat one of them rings or cylinder need to wear in

Chrome should look like fine China little hair line cracks on it

Had mine rebuilt 1700 from my motor never put back on from an aircraft overhaul place in south florida don't know what was done gave them pistons and jugs complete with valves and springs got everything back in bags and never used them found I had a bad crank just info for you

What's wrong with yours

No problem you could pull one of your upper bolts and find the thread size

Mine has a bolt

Talked to mesa picking it up today and see what they can do thank you

Pe 150 or 220 gpu 6 cylinder ft lauderdale fl

I have a few gpu engines dual mag but need cranks does any one know of a machine shop that can weld and redo the cranks then harden or nitrite them I know I should put money some where else but it's what I got

Price ngq 72 lhr shipped to 33309

You can't kink or do sharp bends with mechanical senders

No problem good luck

I have a 78 lhr 3 blade h sensenich in ft lauderdale make offer was going to see if I could get it cut down but could sell make offer

Airtecinc

Looks like someone held the shrimp in front of the other picture I see hoofs

So it's not a junk yard ford it's a built motor that's what I was wondering I was wondering if it was a 460 with gear reduction or small block with reduction any one running a 460 dd and how does it run

Yeah that's what I was thinking too was wondering more about motor prop and reduction unit I'm a ford guy looking to build a nice ford boat I have a 14 ft combee and a 12 Hamant hulls to work with

Don't know that part just saying ehat I saw in the video so you could keep going on your assembly