Check out Gluvit

Check out Gluvit

Thank you.

Hey Guys,

The ring gear on my 0-360 is slipping, it spins but doesn't turn the flywheel. . It's been peened a few times and looks like somebody shot with bird shot. Is replacement of the flyywheel and ring gear the best option? Thanks for your help. Ed

Roger. After running it for a while it was 139 at inlet and 124 at outlet. Air temp wa saround 65 F.

I blocked air flow on half the oil cooler and temp came up to 140 after running the engine for about 5 minutes. CHTs were around 300 by temp gun. Seems as if the cooler air temps and larger cooler are keeping the oil temp down. What size oil cooler should an o360 have in Florida? Seems like the 1st ...

The temp was reading up to 220 with the old oil cooler, so a bigger cooler was put on. I will get a temp gun and check for difference in temps at inlet and outlet then post the results.. Thank you all for your inputs. It is very much appreciated.

Oil pressure is running at 80 psi.

Happy New Year to All, 'Im running an Lycomming 0360. I had a friend put a new(used) oil cooler on it. After I got it back I ran it and the engine was hot . I noticed I my temp gauge was not working. I checked the sending unit in hot water and it reads accurately against a cooking thermometer. What ...

Thanks much. Will do.

Hey guys,
I'm running a Lycoming 0360 with an MA 4-5 carb. What should I run the lean/rich lever at? Ive been told to run it full rich to keep the engine cool but also to lean it out to save fuel. Any comments are apreciated. Thanks, Ed

Roger that. Thanks

howdy folks. got a question about a n o360 for yall. I noticed my oil pressure has gone from 40 at low rpm and 90 at high rpm to 80 at idle and peggin the dial at 2000. any ideas ? thanks.