Engine stand set up

Automotive powered airboat discussion.
Southern Airboat Member
Posts: 112
Joined: Sun Nov 13, 2016 7:16 am
Location: St.martinville , Louisiana

Engine stand set up

Postby Basin_Runner355 » Wed Jul 05, 2017 6:58 am

I recently got me some new blades water walker 2 blades. Falcons on a zz4 355 2:1 belt reduction. I was told to measure the bottom of the reduction to the top of the t-bar runners. Then measure from top of t/bar runner to the center of the front engine mount bolt and should Be the same we'll I'm bout 5/16 lower in the back than in the front would making it dead level help my ground running any.
14ft diamond back zz4 355sbc 2:1 belt drive reduction with a 78 water walker falcons pitched at 5200

Return to “Automotive Power Only”

Who is online

Users browsing this forum: SHOOTER250 and 6 guests