A general, non-powerplant specific, discussion on airboat technology, ie., hulls, rigging, polymer, etc..
3 posts • Page 1 of 1
- Southern Airboat Member
- Posts: 275
- Joined: Thu Mar 18, 2010 6:32 pm
- Location: Melbourne, FL
I am about to paint my rigging using Rustoleum's professional line paint and use the majic catalyst hardener and could use some tips. How much should I thin? How long between coats? Should I sand between coats? Any tips would be appreciated
13' 6'' Cotton Mouth 220 GPU 70'' signature series
When in doubt, and all else fails, read the data page and follow the instructions!!
Airboating is like marriage: There are unlimited ways a person can be right, and somehow still be wrong at the same time!!
Who is online
Users browsing this forum: No registered users and 7 guests