• If you log in, the ads disappear in the forum and gallery. If you need help logging in or getting registered, send request to: webmaster@southernairboat.com

160 prop problem

T

T-S-Jr.

Well-known member
i have a 160 lyncoming the flywheel has the right bolt pattern for the prop on it with no prop adapter can i bolt the prop right to the flywheel without the adapter all looks good without it???
 
thanks for the info i was worried because i just got a new water walker and the bolts are to long like they are for a prop adapter setup
 
If the bolts are to long just cut them to size. When you put a bolt in just hand turn it to make sure it will clear all the way around. Make sure your Mags are off. Sometimes if the bolts are too long they will hit you case some where.
 
ya that is the problem i was having i was just going to get shorter bolts just wanted to make sure that i could do that thanks again!!
 
JUST BREATH SON !!! IN AND OUT ........LOL....... I TOLD POOR TOM HE WAS MISSING HIS PROP ADAPTER AND HE PULLED HIS TAPE AND SEEN THAT WOULD PUT HIM RIGHT ON HIS TRANSOM AND DONE THOUGHT HE WAS BISCUITS !!! I THINK HE'S HAD 4 FRED SANFORD STROKES TONIGHT.LOL..:D :D :D :D GO GET THE NEW BOLTS , BOLT HER ON AND LETS RIDE BRO.....
 
Not jacking this thread, but can you post a pic of your motor stand and a good pic of the rear mount for the 0320. thanks
 
You must log in or register to reply here.
Back
Top